|
|
|
|
|
|
|
|
|
|
Deeply understand the use principle of the rotary cutting machine, why is the owner suddenly stuck?
|
|
Golden wheel rotary cutting machine is a powerful helper for wood production and processing of wood manufacturers. With it, not only the work efficiency is improved, but also the labor force is saved, and the economic benefits of the enterprise are improved. Therefore, the golden wheel rotary cutting machine is very popular in plate manufacturers. Enter any board factory, you can see the busy work of the rotary cutting machine, a thick and long wood in its work, into a wide and thin board, smooth white board appeared in people's sight. The inevitable disadvantage of the rotary cutter is that the rotary cutter needs to be maintained from time to time. Otherwise, once it is dull, it will cause damage to the board, the speed of rotary cutting will become slow, and even the wood may get stuck. This requires the staff of the rotary cutting machine to maintain the rotary cutter regularly.
Deeply understand the use principle of the rotary cutting machine, why is the owner suddenly stuck?
The rotary cutter is suddenly stuck. In addition to being related to the rotary cutter, other factors can also cause it to jam. In such a case, first stop the machine and cut off the power supply. Then check whether the saw blade is not tightened, or the saw blade is not sharp for a long time, or the belt is slipping or damaged. Then adjust and replace it according to the actual situation. The wood hardness is too high, the machine is too hard, and the machine power is small, resulting in stuck, and the installation angle of the cutter head is checked one by one The root cause of the problem will be found and solved.
Use principle of rotary cutting machine
Use principle of rotary cutting machine:
1. When the rotary cutter sets the minimum processing residual wood segment, the minimum setting value should not be less than 30mm, otherwise it is easy to cause machine failure.
2. When setting the stop point, the upper limit of the set value shall not exceed the maximum stroke of the equipment, and the lower limit shall not be less than the set value of the machining surplus, otherwise the machine will not work.
3. The rotary cutter should be used within the scope of application specified in the technical characteristics. Some manufacturers use it to cut plastic for drawing convenience, resulting in serious deformation of the plastic, and also damage the use of the rotary cutting machine, so don't want to use more than one machine.
4. After each use of the rotary cutting machine, the upper and lower waste materials should be removed, so as not to cause the machine to jam, but also affect the rotary cutting efficiency and the service life of the machine.
Gold wheel rotary cutting machine
Through the understanding of the above content, we know that if we want to make the rotary cutter less failure, it is very important to master the use principle of the rotary cutter. If you want to know more about rotary cutting machine, please pay attention to us!
|
|
|
|
|
|
|
|
|
|
|
