|
|
|
|
|
|
|
|
|
|
What are the common faults and troubleshooting methods of the rotary cutting machine? [Jinlun machin
|
|
Rotary cutting machine is often seen in our life, and we all know that it is a kind of machinery to deal with wood, so there will be some problems in the process of our use. Let's take a look at how to deal with these faults.
What are the common faults and troubleshooting methods of the rotary cutting machine? [Jinlun machinery]
1. Power on, the indicator light is on, and the motor cannot be started. Cause: lack of phase of power supply or virtual connection of main control line. Solution: maintenance power supply and control line and general stop button.
2. The sheet is thin and thick. Cause: the knife is high or low, the gap is not consistent with the feed change wheel, and the wood is on the inside and outside. Solution: refer to the adjustment chart to adjust the height of the knife, adjust to the seam and change the wheel, change the wood.
3. When the normal rotary cutting, it will feed automatically and stop when it goes forward. reason:
(1) Virtual connection of feed circuit;
(2) The electromagnetic clutch plate slips and the knife is too high.
resolvent:
(1) Check whether the feed line is connected falsely;
(2) Clean the clutch plate with gasoline or diesel oil and adjust the knife height.
4. The sheet is thick in front and thin in the back. Cause: the knife is low and the seam is too small. Solution: refer to the tool adjustment diagram, adjust the knife height and seam.
5. The tool does not retract automatically when hitting the backward travel switch. Cause: the travel switch and retraction control circuit are open. Solution: replace the travel switch and repair the circuit.
6. When the cutter is retracted automatically, it will not stop when the travel switch is hit, and the total stop button will not work. Cause: the contact point of retraction is not loose. Solution: grind the contact and replace the new contactor.
7. The thickness of the cross section of the sheet is uneven. Cause: the blade is not straight and the gap size is not consistent. Solution: sharpen the knife again and adjust the blade.
8. The panel can not be connected. Causes: the knife is too high and too low, the knife gap and feed change wheel are not well matched, and the internal and external surfaces are. Solution: adjust the height of the knife, knife gap and feed change wheel, change wood.
Rotary cutting machine
The above is about the rotary cutting machine fault and troubleshooting content, if you encounter the problem described above, then you can use the corresponding solution to deal with it to see if it can solve your problem. Jinlun Xiaobian here sincerely hope to help you. If you want to know about other problems of rotary cutting machine, please pay close attention to us!
|
|
|
|
|
|
|
|
|
|
|
